A Top company - serving Quincy, MA

Gelco Crown Repair Nationwide

Every visit starts with

Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed

Worth knowing

Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.

Styles & brands we work with

Sweep & inspection
Sweep & inspection
Caps & crowns
Caps & crowns
Flue relining
Flue relining
Masonry repair
Masonry repair
Gas fireplace service
Gas fireplace service

Before & after – our own jobs

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Gelco Crown Repair: The Quincy Owner’s Guide

Gelco crown repair in Quincy typically runs $450 to $900 installed, and we stock the materials on the truck so most jobs are done in a single visit. You’ll usually find the problem the same way every homeowner does: water staining on the ceiling near the chimney, or a crown that’s visibly cracked and spalling after a few New England winters. The crown is the concrete cap at the top of your chimney, and when it fails, water gets in and starts working its way down through the brick.

Professional masonry contractor performing a brick chimney rebuild on scaffolding nationwide

Call (781) 277-4630

Which Gelco Models This Applies To

Gelco crowns are poured concrete replacement caps sized to the outside dimensions of your chimney, not a specific fireplace model. What matters is the flue arrangement: single-flue, double-flue, or a flue with a surrounding chase. Around Quincy, the older colonials from the 1920s through the 1950s skew toward single-flue crowns measuring roughly 16 to 20 inches square at the top, while the split-levels and ranches toward Wollaston and Houghs Neck often run double-flue with a wider pour. Here’s the compatibility gotcha: a Gelco crown has to overhang the brick by at least two inches on every side to shed water properly. If someone poured a crown that sits flush with the brick face, it’s failing even if it looks fine from the ground. We measure before we order or pour anything. Top Hat Chimney is an independent service provider, not affiliated with Gelco, but we’ve installed and repaired their crown systems for years and stock the matching sealants and patching compounds on the truck.

Signs Your Gelco Crown Repair Is Failing

  • Hairline cracks you can see from the ground. Concrete crowns crack from freeze-thaw cycling. Quincy gets twenty-plus freeze events every winter, and water finds every one of those cracks. A cracked crown is a working leak, even if the crack hasn’t opened up wide yet.
  • Spalling or flaking concrete on the crown surface. This means water has penetrated past the surface and is breaking the crown apart from the inside out. In the neighborhoods near the quarries, this shows up faster because the local stone dust in the air settles on crowns and holds moisture against the surface.
  • Water stains on the ceiling or walls near the chimney. By the time you see this inside, the crown has been leaking for a while. The stain usually shows up on a corner of the chimney chase or along the ceiling line in an upstairs bedroom.
  • Chunks of concrete in the gutter or on the roof below the chimney. Crown material that has separated and fallen off means the failure is active. If you can see missing pieces from the ladder, the crown needs repair now, not next season.
  • Damp smell in the attic or a musty fireplace in the summer. A failed crown lets water into the chimney structure itself, and that moisture sits. In a Quincy summer, that damp brickwork smells exactly like a wet basement.

Replacement Cost & What’s Included

In Quincy, a Gelco crown repair or replacement installed by us runs between $450 and $900. The range comes down to two things: crown size and the condition of the underlying brick. A single-flue crown on a standard colonial chimneystack is on the lower end. A double-flue crown with custom overhang dimensions, or one where the top courses of brick need repointing before the crown goes on, runs higher. Here’s what’s always included: removal of the old crown material, inspection of the top courses of brick, any necessary minor repointing included, a new poured crown or Gelco-compatible repair system, and our 90-Day Done Right Promise in writing. The price you approve before we start is the price on your invoice. If you’re over 200 on the repair, take the $40 off. Seniors and veterans, it’s 10% off every time.

DIY or Call Us?

You can safely check a few things from the ground with binoculars: visible cracks, missing chunks, or a crown that sits flush with no overhang. You cannot safely patch a crown from a ladder without the right materials and a working knowledge of how the crown needs to shed water. Every time we see a homeowner caulk a crown crack with silicone, we see the same outcome: the water just finds another path, and now the patch job has to be ground out before the real repair can happen. Crown work on a real roof with real pitch in Quincy is not a ladder-and-caulk job. If you want to know whether it needs full replacement or a repair will hold, call (781) 277-4630 and we’ll come look. We’ll show you the camera footage before we touch anything.

FAQs

Need Chimney Cleaning help in Quincy? Licensed & insured · Camera-inspected response · free estimates
Call (781) 277-4630
Local Service Coverage

Request a Free Estimate in Quincy

Tell us what you need - Top Hat Chimney responds fast. No obligation.

By sending this request, you agree to our Privacy Policy and consent to being contacted by telephone, text message, or email about your request, including by the independent contractors we may refer it to.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch